FARGO Electronics DTC, DTC, DTC, DTC DTC color id printers, 10 Cleaning Cards, 10 Cleaning Pads, 10 cleaning tapes, full instructions. FARGO Electronics DTC, DTC, DTC, DTC DTC color id printers, DTC/ Dual hopper; PVC cards “); auto or manual feed. HID GLOBAL, HID, the HID logo, FARGO, and iCLASS, are .. installed and used in accordance with the instruction manual, may cause.
|Published (Last):||28 April 2016|
|PDF File Size:||17.76 Mb|
|ePub File Size:||3.60 Mb|
|Price:||Free* [*Free Regsitration Required]|
This confirms that the new Printhead Assembly is functioning properly. Viewing The Report Supplies Press the Reset button to clear the entire existing error log and start a new log. Insert cards neatly stacked. Card jammed in the Print Station or card flipping area of the Printer.
Push firmly to ensure both are securely connected. Insert the Cleaning Cartridge back into the Printer. Page – Defining the Area to activate the Card G Reviewing The Shift Data Left Select this option to shift the recorded magnetic data to the left-hand side of the card’s Magnetic Stripe. See the next page.
Fargo DTC500 Specifications
Card Lamination Module Cards from the Printer before making any repairs, unless otherwise specified. Motor to the front side plate. Select the Print K Only option a to print all black in the designated areas only with the resin black K panel or b to print resin black onto a white background to maximize the sharpness of printed text and barcodes.
Includes USB to Parallel converter, 6 ft.
Card with the K Panel Resin tab procedure on the next page. Ensure that the Printer has received data at the speed that it requires. Confirm that the driver is current by checking at: Lift up on the top bracket of the Printhead Assembly. If the test card does not look like the sample shown below, go to step 5 to adjust the Ribbon Tension.
Print a test card as described in Step 1. Replacing The Main Board d Remove the two mounting screws at the middle and lower section along the left edge of the circuit board. Got it, continue to print.
FARGO DTC SPECIFICATIONS Pdf Download.
Change the setting on the small increments. In this case, rotate the adjustment knob counter-clockwise.
Move the slide to the right to cause dtc551 heat to be used, thus generating a darker print. Disconnect the two cable connectors from the back of the Sensor board.
FARGO Electronics DTC, DTC, DTC, DTC DTC color id printers
Select Optimized for Photo when printing photo quality images with resin. Printer Adjustments Cards from the Printer before making any repairs, unless otherwise specified. By default, this option is set to print and overlay the entire card. Page – Selecting the Defined Area s with the K Decompress mahual file by double-clicking on the designated icon. Step Procedure Select the Rotate Front Degrees option to rotate the image on the front of the card dhc515 degrees when printed.
FARGO Electronics DTC500 Series Troubleshooting Manual
Select this option to shift the recorded magnetic data to the left-hand side of the card’s Magnetic Stripe. In most cases, the default settings of these options will suffice.
See the Replacing the Flipper Home Sensor procedure on the next page. Page of Go. Embedded Fonts and Barcodes Option: This is the fastest way to apply the film lamination, yet it provides the lowest film durability. It is not possible to apply an overlay and a SmartShield image to the same side of a card. msnual
Do not reverse the overlaminate roll. Enter these values into the X and Y boxes, as shown below. However, it will work best with a standard resin black Ribbon.
See the next page for a photo display. Release the plastic tabs in the four corners of the cover. See the Updating the Printer’s Firmware on page Remove any debris that may be inside. To order additional materials, please contact your authorized reseller.